Best posts made by AlexanderH

Hello, I am Alexander and probing a lot with Rexygen, with good results until now. However, at this moment I am trying to read data from a PCF8574A, without succes. I am new with respect to the Rexlang block and i2c.

Below my code:

/************************************************************
*

• REXLANG - Using the PCF8574A as Digital Input via I2C

*************************************************************/

string parameter(0) i2c_dev; // the I2C bus is defined by the p0 parameter

//assigning inputs to variables, these variables are READ-ONLY
long input(3) digital_out; //the signal controlling the outputs is connected to input u3 of the REXLANG block
long output(10) digital_in; //the state of the input pins is published via output y10 of the REXLANG block

//declaration of variables
long i2c_bufTx[3]; //buffer for transmitting data
long i2c_bufRx[3]; //buffer for receiving data
long i2c_bus_handle;
long i2c_chip_address;
long i2c_write_count;
long i2c_read_count;
long i2c_ret_fun;

//the init procedure is executed once when the REXLANG function block initializes
long init(void)
{
i2c_bus_handle = OpenI2C(i2c_dev); // open I2C bus
i2c_chip_address = 0x38; // 7-bit address of the I2C device

i2c_ret_fun = I2C(i2c_bus_handle, i2c_chip_address, i2c_bufTx, i2c_write_count, i2c_bufRx, i2c_read_count);

return 0;

}

//the main procedure is executed once in each sampling period
long main(void)
{
//Reading inputs
i2c_bufTx[0] = 0x71; //Slave address (0x38) including the reading bit (1)
i2c_bufTx[1] = digital_out; //masking the data to control the outputs
i2c_write_count = 2;
i2c_read_count = 0;
i2c_ret_fun = I2C(i2c_bus_handle, i2c_chip_address, i2c_bufTx, i2c_write_count, i2c_bufRx, i2c_read_count);

//Controlling outputs  
i2c_write_count = 0;
i2c_read_count = 1;
digital_in = i2c_bufRx[0]; //publishing the received data    
i2c_ret_fun = I2C(i2c_bus_handle, i2c_chip_address, i2c_bufTx, i2c_write_count, i2c_bufRx, i2c_read_count);

return 0;

}

//the exit procedure is executed once when the task is correctly terminated
// (system shutdown, downloading new control algorithm, etc.)
long exit(void)
{
if(i2c_bus_handle>=0) Close(i2c_bus_handle); // close I2C bus
return 0;
}

Hopefully somebody can help me and tell/show me what I am doing wrong.