@MikeyH Hi Mike,

I'm glad it works for you 😉

For the "variable decimal point" I would use blocks MUL and CNDR. CNDR configure so it reflects the changing of the gain according to the value.

You will probably find many other solutions which will lead you to the desired behaviour (e.g. SSW for switching gain according to the value)

Hope it helps.

Cheers,
Tomas

@apollo Yes, you are right about the indexing. Starting with upcoming REXYGEN release the error message will contain Slave Name and its IP address for better understanding.

Cheers,
Tomas

@cechurat said in Use of the 'MTM__SlaveStation_Connected' signal.:

Status shows time to next reconnect in ms

Hi Scoobsalamander,

glad I could help. You are right, I didn't take to count the timing. Good luck with your project!

Cheers, Tomas

Hello folks,

I just wanted to confirm that reducing the "Max. requests" number to 1 allows multiple Modbus reads of the Click PLC.
I agree that reading registers in groups of 4 or 8 is more elegant and will try that next.

Cheers,
Tom Sisk